Ctek SMARTPASS Bedienungsanleitung PDF herunterladen (Seite 12)

14 • EN

INSTALLATION OF UNIT

1. Attach the temperature sensor holder on a ﬂat surface on

one Service battery. Position it as close as possible to a

positive post.

2. Use the included drill template. Wiring is simpliﬁed if the

units are installed according to the drill template, but other

setups are possible.

3. Install the unit(s) on a surface where it can be properly

ﬁxed and where the unit is not exposed to fuels, oils or

splashes of dirt.

4. Mount the unit with screws intended for the surface and

attach it with one screw in each of the four holes in the

corners of the unit. See picture 1. Mount the unit with M4

or ST4.2 screws. The required torque depends on the sur-

face for mounting. Fig. 1 shows a CTEK D250S. The same

procedure is used for all devices.

5. Attach the cables and mount the cable screws with a

torque of 7 Nm/62 Lb-In. Use tool – hand power without

tools is not enough.

6. The ground cable of the SMARTPASS should be connect-

ed to the ground screw of the DUAL or to any convinient

ground connection point.

INSTALLATION OF CABLES

Figure 1

Figure 2

2Nm/18 Lb -In

7Nm/62 Lb -In

Allen key

WARNING!

D250S DUAL and

SMARTPASS is not reverse

polarity protected.

Disconnect battery poles

before installation.

WARNING!

D250S DUAL is not spark

proof. Provide for good

ventilation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

Ctek SMARTPASS Bedienungsanleitung Seite 12